Miele G 7604 - Page 111

Problem solving guide
111
Problem Possible cause and remedy
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
Fault F601
There is a fault with the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see
“Detergents – Automatic dispensing/AutoDos”).
 Activate the AutoDosfunction and start the
programme again.
If the fault message appears again, there is a technical
fault. You can continue to use your dishwasher by
deactivating automatic dispensing with the
AutoDossensor and manually dispensing the
detergent via the detergent compartment.
 If you wish to use automatic dispensing again,
contact Miele.
At the end of the
programme, the alarm
tone might sound and
the display shows the
following message:
AutoDos maintenance
required
The dishwasher does
not switch off at the end
of the programme.
The dishes may not be
clean because an
insufficient amount of
detergent was
dispensed.
The AutoDos function
is automatically
deactivated during the
programme sequence.
No PowerDisk or an empty PowerDisk has been
inserted or the AutoDos is blocked by residual
detergent. Detergent dosage is insufficient.
The AutoDos function was automatically
deactivated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the AutoDos (see “Detergent – Cleaning the
AutoDos”).
 Insert a full PowerDisk and close the AutoDos lid.
 Clean the lower spray arm (see “Cleaning and care –
Cleaning the spray arms”).
 Confirm each message with OK.
 Activate the AutoDos function by confirming the
message AutoDos available with OK.
 Start the programme again.