11
3. Meter parameters
Before commencing operation, the meter has to be set up. To
do this, the meter must be powered up by the meter control
power supply.
Under section 6, the following parameters should be reviewed
against the default value if necessary:
• CT ratio
• PT ratio
• Neutral current input
• Modbus-RTU setting
• Demand setting
• System setting
• Scroll mode setting and delay time
• Backlight setting
The fl ow maps for the meter is under section 5. It is guideline
for the user to fl ip to the desire window whether in normal
mode or programming mode.
To Next Page
