Mikro DPM380 - Demand Setting

20
6.6. DEMAND SETTING
a. Scroll until ”DMD“ is displayed using the UP or DOWN
button.
b. Press the NEXT button to change interval value. The
“PROG” symbol will displayed and “-”symbol next to
“INT” will blink.
c. Use UP or DOWN button to change value and press
NEXT button to confi rm and change sub-interval setting.
The “-” symbol next to “SUB” will blink. Press UP or
DOWN button to change and NEXT button to confi rm.
d. To proceed next setting press DOWN button. To exit
programming mode, press the PROG button. The user
will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.
NOTE: Demand setting default value is 60/4