Mikro DPM380 - Scroll Delay Setting

27
6.13. SCROLL DELAY SETTING
a. Scroll in programming mode until ”Scrl dELY“ is displayed
using the UP or the DOWN button.
b. This function is to set time interval for scroll window.
c. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to set 1sec to 10secs
interval.
d. Press the NEXT button to confi rm the new setting.
e. To proceed next setting, press DOWN button.
f. To exit programming mode, press the PROG button. The
user will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.
NOTE: Scroll delay time default value is 10 seconds.