21
6.7. SYSTEM SETTING
a. Scroll in programming mode until ”SYSt sEt“ is displayed
using the UP or the DOWN button.
b. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to toggle 3-phase 4-wire
“3P4r” or 3-phase 3-wire “3P3r” symbols.
c. Press the NEXT button to confi rm new setting.
d. To proceed next setting press DOWN button. To exit
programming mode, press the PROG button. The user
will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.
NOTE: System setting default value is 3-phase 4-wire
To Next Page
