26
6.12. SCROLL SETTING
a. Scroll in programming mode until ”Scrl SEt“ is displayed
using the UP or the DOWN button.
b. This function is to turn ON/OFF scroll mode. If turn
on, when the display is idle the meter will shows each
window in normal mode base on the scroll delay setting
time.
c. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to toggle “OFF” or “ON”
symbols.
d. Press the NEXT button to confi rm the new setting.
e. To proceed next setting, press DOWN button.
f. To exit programming mode, press the PROG button. The
user will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.
NOTE: Scroll setting default value is OFF
To Next Page
