Mikro DPM380 - Reset Demand Register

23
6.9. RESET DEMAND REGISTER
a. Scroll in programming mode until ”dMd rSt“ is displayed
using the UP or the DOWN button.
b. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to toggle “YES” or “NO”
symbols.
c. To abort clearing demand register, select “NO”. To clear
all demand register select “YES”.
d. Press the NEXT button to confi rm the new setting.
e. To proceed next setting, press DOWN button.
f. To exit programming mode, press the PROG button. The
user will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.