Mikro DPM380 - Backlight Setting

29
6.15. BACKLIGHT SETTING
a. Scroll in programming mode until ”bcLt“ is displayed
using the UP or the DOWN button.
b. This function is to turn off backlight after 10minutes idle.
c. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to toggle “OFF” or “ON”
symbols.
d. Press the NEXT button to confi rm the new setting.
e. To proceed next setting, press DOWN button.
f. To exit programming mode, press the PROG button. The
user will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.
NOTE: Backlight setting default value is OFF