Mikro DPM380 - Reset All Energy Register

22
6.8. RESET ALL ENERGY REGISTER
a. Scroll in programming mode until ”EnEr rSEt“ is displayed
using the UP or the DOWN button.
b. Press the NEXT button. The “PROG” symbol will blink.
Use the UP or DOWN button to toggle “YES” or “NO”
symbols.
c. To abort clearing energy register values, select “NO”. To
clear all energy values select “YES”.
d. Press the NEXT button to confi rm the new setting.
e. To proceed next setting press DOWN button.
f. To exit programming mode, press the PROG button. The
user will be prompted to confi rm the saving of settings if
change is made. Refer section 6.16.