. A complete Parts List is available at www.MillerWelds.com
OM-253392 Page 19
5-6. Wire Gun Connection Inside Unit
Ref. 254 249-C
1 Gun Securing Knob
2 Gun Block
3 Gun Outlet Wire Guide
4 Gun End
Loosen knob. Insert end of gun through
opening in front panel until gun end bottoms
against gun block. Tighten knob.
5 Trigger Control Cable
6 Four Pin Trigger Control Cable
Receptacle
Route trigger control cable through MIG
gun hole.
Connect plug on end of cable to four pin
receptacle inside unit.
Correct Incorrect
. Be sure that gun end is tight against drive assembly.
44
Ref. 801 987
3
6
5
2
1
4
To Next Page
Loading...
