. A complete Parts List is available at www.MillerWelds.com
OM-253392 Page 34
6-8. Viewing Burn-In Information (Menu 5 Of 10)
. Burn-In information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button four times after entering setup to enter the Burn-In information screen.
Burn-In information displays electrical information unique to the unit.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
. Cycle unit power before welding to complete initialization process.
6-9. Viewing Software Information (Menu 6 Of 10)
. Software information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button five times after entering setup to enter the Software information screen.
Software information displays software information unique to the unit.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
. Cycle unit power before welding to complete initialization process.
6-10. Viewing Primary Power Information (Menu 7 Of 10)
. Primary Power information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button six times after entering setup to enter the Primary Power Logs screen.
Primary Power Logs screen displays unit power on time.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
. Cycle unit power before welding to complete initialization process.
Notes
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
To Next Page
Loading...
