Installation
16
Installation of the SmartPak cartridge
ATTENTION
Open the Tank Outlet Valve before installing a new SmartPak cartridge. This
keeps the tank from filling until the SmartPak cartridge is rinsed out (A).
HAZARD Do not touch the UV Lamp when replacing the SmartPak cartridge.
Installation
A
• Make sure the front cover is opened.
B
• STANDBY should be viewed on the Display (B).
• Remove the SmartPak cartridge from its shipping box.
• Remove the protective caps on the ports of the SmartPak cartridge
and from the system.
C
• Locate the O-rings on the ports (C). Wet them with water. It is
preferable to wet them with ultrapure water.
To Next Page
Loading...
Need help?
General
