Maintenance
47
Flush Mode
ATTENTION The Tank Outlet Valve should be left open during FLUSH mode.
H
• The system will now go into FLUSH mode for 15 minutes (H). This is
done to empty the SmartPak cartridge of air and hydrate the
material inside.
I
• When FLUSH mode is finished, the system will go into FILLING TANK
mode automatically (I).
Rinsing the SmartPak cartridge
J
• Let FILLING TANK mode run for a minimum of 2 hours with the Tank
Outlet Valve open and placed to the drain. This will completely rinse
the purification media inside the SmartPak cartridge.
for sensitive applications, it is recommended to leave the system in
FILLING TANK overnight to ensure complete rinsing of the RO
membrane.
• Close the Tank Outlet Valve (J) and connect it back to the system if
needed. The tank will start to fill up with water. It could take
approximately 1.5 to 2 hours to fill the tank. When it is full, the
Display will indicate a full tank by illuminating the symbols
representing the Tank Level
(see Section Understanding the Display)
.
• The Vent Filter needs to be installed. See
Section Installation of the
Vent Filter
.
To Next Page
Loading...
Need help?
General
