Millipore direct-q 3 R User Manual

Troubleshooting
71
Problem Possible causes What to do
UV System only
• The UV Timer is exhausted. • Replace the UV Lamp. See
Section
How to Replace the UV Lamp (UV
System only).
• After a new UV Lamp has been
installed, reset the UV Timer. See
Section How to View or Reset the
UV Lamp Timer (C05).
UV System only
• The UV Lamp is not installed
correctly or not installed at all.
• Power OFF the system and reinstall
the UV Lamp.
• If the red UV Lamp Alarm is still
displayed, then contact your
technical support.

Millipore direct-q 3 R Specifications

General

Brand	Millipore
Model	direct-q 3 R
Category	Water Filtration Systems
Language	English