Millipore Simplicity - Installation; Unpacking; Selecting a Site

Page 11/36
Page 11/36
Page 11/36
Unpacking ______________________________________________
After unpacking the shipping container you should find (Figure 2):
(A) Simplicity water purification system with reservoir
(B) User manual
(C) Point-of-use valve hose barb connector for purging a new SimPak
Ordered separately
(D) SimPak purification pack
(E) Reservoir vent filter
(F) SimFilter
Selecting a site for the Simplicity system _____________________
Warning: Do not plug in the electrical power cord into
a power source at this step.
The Simplicity system has been designed to be placed on any
laboratory bench (or suitable alternative). See the section
“Dimensions” page 10 of this manual for information related
to the space needed to remove and install the reservoir.
___________________________________________INSTALLATION
Present?
Yes No
Unpacking ______________________________________________
After unpacking the shipping container you should find (Figure 2):
(A) Simplicity water purification system with reservoir
(B) User manual
(C) Point-of-use valve hose barb connector for purging a new SimPak
Ordered separately
(D) SimPak purification pack
(E) Reservoir vent filter
(F) SimFilter
Selecting a site for the Simplicity system _____________________
Warning: Do not plug in the electrical power cord into
a power source at this step.
The Simplicity system has been designed to be placed on any
laboratory bench (or suitable alternative). See the section
“Dimensions” page 10 of this manual for information related
to the space needed to remove and install the reservoir.
___________________________________________INSTALLATION
Present?
Yes No
Unpacking ______________________________________________
After unpacking the shipping container you should find (Figure 2):
(A) Simplicity water purification system with reservoir
(B) User manual
(C) Point-of-use valve hose barb connector for purging a new SimPak
Ordered separately
(D) SimPak purification pack
(E) Reservoir vent filter
(F) SimFilter
Selecting a site for the Simplicity system _____________________
Warning: Do not plug in the electrical power cord into
a power source at this step.
The Simplicity system has been designed to be placed on any
laboratory bench (or suitable alternative). See the section
“Dimensions” page 10 of this manual for information related
to the space needed to remove and install the reservoir.
___________________________________________INSTALLATION
Present?
Yes No