Millipore Simplicity User Manual

Page 23/36
Page 23/36
Page 23/36
18. Press the OPERATE button to go from STANDBY to OPERATE mode
19. Open the POU valve and draw around 0.5 litre of water through the SimFilter.
20. Switch the unit to STANDBY mode.
The SimFilter should be changed whenever the product flowrate becomes too low (< 0.3 Litres/mn)
or whenever the SimPak is replaced. The lifetime of the SimFilter is dependent upon the quality of the
feedwater and dependent upon the amount of water dispensed through the unit. It is recommended
to replace the filter during replacement of the SimPak.
Replacing the UV lamp (Only for Simplicity 185) ______________
The UV lamp should be replaced every second year. The age of the UV lamp can be checked during
normal use. See “Consumable lifetime” page 18.
When, the message “EXCHANGE UV LAMP” is displayed, proceed as follows.
UV Lamp replacement
Note: The used UV lamp contains metallic mercury and should therefore be
disposed of by the owner, in agreement with local regulations.
1. Put the Simplicity into STANDBY mode by pressing the OPERATE button. Unplug the
electrical power cord from the power source.
2. Open the Point of Use valve for a few seconds to depressurise the system.
3. Swing the Pack locking handle (Figure 4,E) to the left by pressing on the locking tab
(Figure 4,A).
4. Remove the SimPak.
_________________________________________ MAINTENANCE
18. Press the OPERATE button to go from STANDBY to OPERATE mode
19. Open the POU valve and draw around 0.5 litre of water through the SimFilter.
20. Switch the unit to STANDBY mode.
The SimFilter should be changed whenever the product flowrate becomes too low (< 0.3 Litres/mn)
or whenever the SimPak is replaced. The lifetime of the SimFilter is dependent upon the quality of the
feedwater and dependent upon the amount of water dispensed through the unit. It is recommended
to replace the filter during replacement of the SimPak.
Replacing the UV lamp (Only for Simplicity 185) ______________
The UV lamp should be replaced every second year. The age of the UV lamp can be checked during
normal use. See “Consumable lifetime” page 18.
When, the message “EXCHANGE UV LAMP” is displayed, proceed as follows.
UV Lamp replacement
Note: The used UV lamp contains metallic mercury and should therefore be
disposed of by the owner, in agreement with local regulations.
1. Put the Simplicity into STANDBY mode by pressing the OPERATE button. Unplug the
electrical power cord from the power source.
2. Open the Point of Use valve for a few seconds to depressurise the system.
3. Swing the Pack locking handle (Figure 4,E) to the left by pressing on the locking tab
(Figure 4,A).
4. Remove the SimPak.
_________________________________________ MAINTENANCE
18. Press the OPERATE button to go from STANDBY to OPERATE mode
19. Open the POU valve and draw around 0.5 litre of water through the SimFilter.
20. Switch the unit to STANDBY mode.
The SimFilter should be changed whenever the product flowrate becomes too low (< 0.3 Litres/mn)
or whenever the SimPak is replaced. The lifetime of the SimFilter is dependent upon the quality of the
feedwater and dependent upon the amount of water dispensed through the unit. It is recommended
to replace the filter during replacement of the SimPak.
Replacing the UV lamp (Only for Simplicity 185) ______________
The UV lamp should be replaced every second year. The age of the UV lamp can be checked during
normal use. See “Consumable lifetime” page 18.
When, the message “EXCHANGE UV LAMP” is displayed, proceed as follows.
UV Lamp replacement
Note: The used UV lamp contains metallic mercury and should therefore be
disposed of by the owner, in agreement with local regulations.
1. Put the Simplicity into STANDBY mode by pressing the OPERATE button. Unplug the
electrical power cord from the power source.
2. Open the Point of Use valve for a few seconds to depressurise the system.
3. Swing the Pack locking handle (Figure 4,E) to the left by pressing on the locking tab
(Figure 4,A).
4. Remove the SimPak.
_________________________________________ MAINTENANCE

Millipore Simplicity Specifications

General

Brand	Millipore
Model	Simplicity
Category	Water Filtration Systems
Language	English