Millipore Simplicity User Manual

Page 26/36
Page 26/36
Page 26/36
TROUBLESHOOTING______________________________________
Troubleshooting table _____________________________________
Whenever the Yellow SERVICE LED is blinking, a message is displayed on the screen, which indicates
the nature of the service needed.
STATUS / PROBLEM CAUSE REMEDY
There is no electrical power to - No electrical power. Check the source of power.
the system. - The power cord is not plugged Check the power cord.
into the wall.
The Simplicity system is in - The tank is empty. Fill the tank.
PRODUCT mode but does not - Tank is not well positioned Check tank position
produce any or very little water. - Clogged Point of use filter. Replace the SimFilter
- Tank vent filter plugged Remove tank lid. If flowrate is
OK, replace the vent filter.
- Air is trapped in the SimPak Remove the SimFilter, purge
and the SimFilter. the system.
The system switches The simplicity is pre-set to Re-fill the reservoir if necessary
automatically from produce continuously for and press on OPERATE button.
PRODUCTION mode to 10 min. maximum.
mode to STANDBY mode.
RESISTIVITY < SP The reservoir is empty Fill the reservoir
Resistivity is below the Set Point Install new purification
cartridges.
TROUBLESHOOTING______________________________________
Troubleshooting table _____________________________________
Whenever the Yellow SERVICE LED is blinking, a message is displayed on the screen, which indicates
the nature of the service needed.
STATUS / PROBLEM CAUSE REMEDY
There is no electrical power to - No electrical power. Check the source of power.
the system. - The power cord is not plugged Check the power cord.
into the wall.
The Simplicity system is in - The tank is empty. Fill the tank.
PRODUCT mode but does not - Tank is not well positioned Check tank position
produce any or very little water. - Clogged Point of use filter. Replace the SimFilter
- Tank vent filter plugged Remove tank lid. If flowrate is
OK, replace the vent filter.
- Air is trapped in the SimPak Remove the SimFilter, purge
and the SimFilter. the system.
The system switches The simplicity is pre-set to Re-fill the reservoir if necessary
automatically from produce continuously for and press on OPERATE button.
PRODUCTION mode to 10 min. maximum.
mode to STANDBY mode.
RESISTIVITY < SP The reservoir is empty Fill the reservoir
Resistivity is below the Set Point Install new purification
cartridges.
TROUBLESHOOTING______________________________________
Troubleshooting table _____________________________________
Whenever the Yellow SERVICE LED is blinking, a message is displayed on the screen, which indicates
the nature of the service needed.
STATUS / PROBLEM CAUSE REMEDY
There is no electrical power to - No electrical power. Check the source of power.
the system. - The power cord is not plugged Check the power cord.
into the wall.
The Simplicity system is in - The tank is empty. Fill the tank.
PRODUCT mode but does not - Tank is not well positioned Check tank position
produce any or very little water. - Clogged Point of use filter. Replace the SimFilter
- Tank vent filter plugged Remove tank lid. If flowrate is
OK, replace the vent filter.
- Air is trapped in the SimPak Remove the SimFilter, purge
and the SimFilter. the system.
The system switches The simplicity is pre-set to Re-fill the reservoir if necessary
automatically from produce continuously for and press on OPERATE button.
PRODUCTION mode to 10 min. maximum.
mode to STANDBY mode.
RESISTIVITY < SP The reservoir is empty Fill the reservoir
Resistivity is below the Set Point Install new purification
cartridges.

Millipore Simplicity Specifications

General

Brand	Millipore
Model	Simplicity
Category	Water Filtration Systems
Language	English