Page 15/36
Page 15/36
Page 15/36
The simplicity system should be used in the manner specified by this user’s manual, otherwise the
protection provided by this equipment may be impaired.
Maintaining a minimum level of water in the reservoir _________
The simplicity is fed through the reservoir located at the back of the unit. Whenever the water in the
reservoir reaches half a liter level it is recommended to refill it.
If the simplicity runs out of water, proceed as follows:
1. Press the OPERATE button to go from OPERATE to STANDBY mode.
2. Refill the reservoir.
3. Replace the SimFilter by the hose barb connector and start the unit.
4. Open the POU valve, press OPERATE and draw approximately 0.2 litre of water.
5. Re-install the SimFilter.
Standard displayed messages _____________________________
Your Simplicity system has a number of operating modes which can be activated via the keypad.
Other modes are automatically activated by the microprocessor.
__________________ STANDARD OPERATING OF THE SIMPLICITY
The simplicity system should be used in the manner specified by this user’s manual, otherwise the
protection provided by this equipment may be impaired.
Maintaining a minimum level of water in the reservoir _________
The simplicity is fed through the reservoir located at the back of the unit. Whenever the water in the
reservoir reaches half a liter level it is recommended to refill it.
If the simplicity runs out of water, proceed as follows:
1. Press the OPERATE button to go from OPERATE to STANDBY mode.
2. Refill the reservoir.
3. Replace the SimFilter by the hose barb connector and start the unit.
4. Open the POU valve, press OPERATE and draw approximately 0.2 litre of water.
5. Re-install the SimFilter.
Standard displayed messages _____________________________
Your Simplicity system has a number of operating modes which can be activated via the keypad.
Other modes are automatically activated by the microprocessor.
__________________ STANDARD OPERATING OF THE SIMPLICITY
The simplicity system should be used in the manner specified by this user’s manual, otherwise the
protection provided by this equipment may be impaired.
Maintaining a minimum level of water in the reservoir _________
The simplicity is fed through the reservoir located at the back of the unit. Whenever the water in the
reservoir reaches half a liter level it is recommended to refill it.
If the simplicity runs out of water, proceed as follows:
1. Press the OPERATE button to go from OPERATE to STANDBY mode.
2. Refill the reservoir.
3. Replace the SimFilter by the hose barb connector and start the unit.
4. Open the POU valve, press OPERATE and draw approximately 0.2 litre of water.
5. Re-install the SimFilter.
Standard displayed messages _____________________________
Your Simplicity system has a number of operating modes which can be activated via the keypad.
Other modes are automatically activated by the microprocessor.
__________________ STANDARD OPERATING OF THE SIMPLICITY