MIMAKI CG-100SR2 User Manual

Loading a sheet of media
30
9
Press the jog key or to select
number of pinch rollers to be used.
• When [ROLL. SELECT] is set to [ON], selectthe
number of pinch rollers to be used.
10
Press the key to start to
search the sheet.
• After the sheet width is displayed, dummy cut will be
performed.
11
Press the key to pull out the sheet of the length you want to
use.
12
Input the feed amount using the jog key
or .
• Setting value
In “mm” : 0.1 m to 51.0 m (in increments of 0.1 m)
In “inch” : 1 to 167 feet (in increments of 1 ft.)
13
Press the key.
• The sheet will be fed by the input length.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make
enough room. By feeding out the sheet, you can verify if there is any sheet misalignment or
not.
PINCH ROLL. :3
A=* * * * B=559
CUT1 20 050 0.30
Unit : mm
Displays the detected
size of the leaf sheet.
Displays the current
settings of tool conditions.
ENTER/HOLD
FEED
SHEET FEED: 10 . 0m
SHEET FEED: 8 . 0m
ENTER/HOLD

MIMAKI CG-100SR2 Specifications

General

Brand	MIMAKI
Model	CG-100SR2
Category	Cutter
Language	English