Mindray BeneLink - 1.2 Warnings; 1.3 Cautions

1-2 BeneLink Module Operator’s Manual
1.2 Warnings
WARNING
 The BeneLink module receives parameter, alarm, and waveform data
from external devices but will not modify this data. For example, the
external device may display "---", b u t send "0" to the patient monitor.
 There can be differences between the alarm priorities displayed on
your patient monitors and the priorities displayed on external devices
interfaced through BeneLink. For details please
see "Output signals –
Alarms" section corresponding with each external device.
1.3 Cautions
CAUTION
 First installation and debugging should be executed by Mindray
service personnel or authorized technician.
 Please check the compatibility of the external device and the ID
adapter before connection. Not doing so may may result in failure of
the two devices to work together as desired.
 Ports on the BeneLink module are not conventional network
connectors. They are intended for connecting with the serial port of
designated devices only. Do not connect them to public network
interfaces.
 The signal labels used on the patient monitor may be different from those
given on the external device. For details please see "Output signals
–
Parameters" section corresponding with each external device. The alarms
from external devices may be delayed before transmission to the patient
monitor
.