BeneLink Module Operator’s Manual 10-31
Alarm ID Alarm message Category Alarm priority Source
0xA8F4 Low Vacuum Tech High IABP
0xA8F5
Augmentation Below
limit set
Phys Medium IABP
0xA8F6 Low helium Tech Medium IABP
0xA8F7 Low Battery Tech Medium IABP
0xA8F8 System Failure Tech High IABP
0xA8F9 Electrical Test Failure Tech High IABP
0xA8FA Autofill Failure Tech High IABP
0xA8FB
Autofill Failure - No
helium
Tech
High IABP
0xA8FC Safety disk test failure Tech High IABP
0xA8FD
No patient status
available
Tech
High IABP
0xA8FE Autofill Required Tech High IABP
0xA8FF Low Battery(EXT) Tech Medium IABP
0xA900 Maintenance required Tech Medium IABP
0xA901
Prolonged Time in
Standby
Tech
Medium IABP
0xA902 Poor Signal Persist Tech High IABP
0xA903
Irregular pressure
trigger
Tech
Medium IABP
0xA904
No pressure source
available
Tech
Medium IABP
0xA905 Poor Signal Quality Tech Medium IABP
0xA906
Unable to update
timing
Tech
Medium IABP
0xA907 Sensor IAB Failure Tech Medium IABP
0xA908
Sensor IAB Module
Tech Medium IABP
To Next Page
Loading...