Mindray Consona N9 - Basic Screen & Operation

7 3D/4D
Operator’s Manual 7 - 29
7.13.2 Basic Screen & Operation
Layout
The system supports several types of displaying layout: 2*2, 3*3, 4*4 and 5*5, touch the
corresponding icon on the touch screen to select, and the selection [Slices Number] changes
accordingly.
Reference image
Tap [A], [B], or [C] to select the reference image.
Slice and slice line
• Central slice: the central slice line corresponding plane are the central slice, which is marked
with a green “*” at the upper left corner of the image.
• Tap to place the slice lines vertically, and touch to place the slice lines horizontally.
• Active slice: the green slice line corresponding plane is the active slice, which is marked with a
green box. The default active slice is the central slice.
• Slice order number: indicating the order of the slices, the order of central slice is “0”, the slices
before the central slice are marked with negative integral numbers, and the slices after the
central slice are marked with positive integral numbers.
• Slice position (to the central slice): displayed at the upper left corner of each image, indicating
the position of each image (such as -6mm, -3mm, 3mm, 6mm).
1
A plane (the current
reference image)
2B plane 3
C plane
4
Central slice line
(Current active slice)
5 Slice line 6
Space between two
slice lines
7
Y-axis 8 X -a xi s 9
Slice position (to the
central slice)
10
Slice order number 11 Central slice mark 12
Active slice be
highlighted in green
1
4
7911 108
12
5
6
2
3