3 - 6 Operator’s Manual
3 System Preparation
• DO NOT rush shutdown the system. It may make the data corrupted.
• If you will not use the system for a long period of time, you should disconnect the mains
power, and turn off the power to all peripherals connected to the system.
To power off your system normally.
1. Press the power button to see the option:
– Shut down: To power off the system normally.
– Standby: To enter standby status.
– Cancel: To cancel the operation.
2. Select [Shutdown] to power the system off.
3.3.5 Standby
If the system is disconnected from the AC power, make sure not to press the power button in the
standby status. In this circumstance, to exit standby status or power off the system, connect the
system to the AC power before pressing the power button.
To Enter Standby
• Open [Setup] > [System] > [General] to set the time for screensaver and standby. The system
goes into the screen saving status if without the operating. The system then goes into the
standby status if without the operation during expiring the standby time.
• Press the power button to select [Standby]. The system enters standby status.
To Exit Standby
Press the power button.
When the system enters the standby status, if need to power off: Press the power button to exit the
powering-off status and then power off the system.
3.4 Monitor Position Adjustment
Gently hold the bottom edge of the monitor when adjusting its position.
To Next Page
Loading...
