2 System Overview
Operator’s Manual 2 - 13
2.10 Control Panel
No. Key Name Description
1. / Power button/
Indicator
Power button: Turn on/turn off the system.
Indicator:
• AC (Alternating current). It turns on at AC
supply.
• Standby. It blinks in orange in standby status.
• Hard disk indicator. It blinks when reading the
disk.
2. P2 User defined
key
Set by the user in the Preset.
3. PW/Y PW mode key • Press to enter or exit the PW mode. When the PW
mode is enabled:
– If the Mark is not displayed, then press to
display the Mark line.
– If the Mark is displayed, then press to enter
PW mode.
• Rotate to adjust PW/CW gain; while in 3D/4D mode,
rotate the knob to make the 3D image rotate around
Y axis.
4. C/Z Color mode key • Press to enter or exit Color mode
• Rotate to adjust Color/Power gain; while in 3D/4D
mode, rotate the knob to make the 3D image rotates
around Z axis.
2
12
3
7
8
12 13 14
18 19 20 21 22 23
24
15 16 17
9
10 11
5
4
6
To Next Page
Loading...
