2 System Overview
Operator’s Manual 2 - 21
Tap and hold the screen to enter control editing stage.
• Moving tabs on 3D/4D viewing status
On 3D/4D viewing status, tap and hold the desired tab on the touch screen, and then drag the
tab to adjust its position.
2.13 Warning Labels
The warning labels are attached to this system in order to call your attention to potential hazards.
The warning labels use the same signal words as those used in the operator’s manual. Read
operator’s manual carefully before using the system.
The name, pattern and meaning of each warning label are described as follows:
Function Operations
Adding a control Tap to select a button to add.
Add a user-defined
control
In comment and body mark editing status, tap and then tap
[Custom] to bring out the dialogue box for adding user-defined
controls. Enter the control name and tap [OK].
Delete a control Tap of the target control and tap [OK] to delete.
Change the control
position
Tap and drag the control to the desired position.
No. Warning Labels Meaning
1 1. Do not place the system on a sloped surface.
Otherwise the system may slide, resulting in
personal injury or the system malfunction.
Move the system slowly on the slope by two
people and make sure that the support arm is not
extended.
2. DO NOT sit on the system.
3. DO NOT push the system when the casters are
locked.
4. Read this information carefully before using the
system.
2 Warning; Crushing of hands when operating the
main unit keypad, touch screen, display screen,
display supporting arm, etc.
To Next Page
Loading...
