Mindray Consona N9 - Operation Controls

7 - 32 Operator’s Manual
7 3D/4D
3. Tap [Thickness] on the touch screen, and then rotate <Angle> to adjust imaging thickness.
4. Save images as necessary.
SCV+CMPR operation
Perform the following procedure:
1. Enter SCV
+
.
2. Tap [A], [B] or [C] to select current window.
3. Tap [CMPR] to turn on the CMPR function. Window A on main screen displays the current
window and three other windows are blank.
4. Select reference section, perform rotation and shifting operations to adjust image.
5. Tap [1], [2], or [3] button in [Active Quadrant].
6. Select trace options: tap [Line], [Trace] or [Spline].
7. Draw on the reference image. You can draw three curves at most and the CMPR imaging for
the curve are displayed in the selected [1], [2] or [3] window respectively as shown in figure
below.
8. Perform rotation and shifting operation to reference line.
9. Save images as necessary.
7.14.2 Operation Controls
SCV
• Current Quadrant
Tap [A], [B] and [C] to select current active section image.
•Reset
Click [Reset All] in Reset field to reset parameters, orientation and zooming status.
CMPR
Trace Options
•Line