Mindray DC-70 Service Manual

3-14 System Installation
2D scanner 1D scanner
3.5 System Configuration
3.5.1 Running the System
Connect the AC power; make sure the ultrasound system and other optional devices are correctly
connected.
When the AC power indicator on the control panel is light on (indicator
is in green), press the
power button
on the control panel to turn on the system.
3.5.2 Enter Doppler
After system is turned on and wait for about 1 minute (for system initialization), it will enter into
Doppler interface, see the figure below:
Bracket
Bracket
Scanning surface

Mindray DC-70 Specifications

General

Power Supply	100-240V AC, 50/60Hz
Imaging Modes	B-mode, M-mode, Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Probes	Convex, Linear, Phased Array, Volume
Connectivity	USB, Ethernet, VGA
Advanced Features	3D/4D Imaging
Applications	Abdominal, Obstetrics, Gynecology, Cardiac, Small Parts, Vascular, Musculoskeletal, Urology
Weight	Approx. 85 kg
Operating System	Windows-based