Image Optimization 5-95
Tap [RLB View] on the touch screen to enable the function and the button will be
highlighted.
After the RLB View function is enabled, the less qualified region is displayed in
hollow. The hollow region can be seen in B images. The hollow region
corresponds to the purple region in the reliability image.
HFElasto
This feature is used to improve the frame rate (FR).
Tap [HFElasto] on the touch screen to enable the function and the button will be
highlighted.
Invert
Invert the map to satisfy the different doctors to define the benign lesion or
malignant lesion.
Tap [Invert] to enable the function (the soft key is highlighted).
iLayering
To increase the layer display in elasto images.
Tap [iLayering] to enable the function.
Filter
To filter the noise of the elasto image.
Rotate the knob under [Filter] on the touchpad.
The higher the level is, the smaller the noise of the elasto image becomes, and the
clearer the edge of the field target appears.
The system restarts scanning B image and E image after the filtering is completed.
5.13.2.3 Measuring
Press <Caliper> to enter general measurements.
Press <Measure> to enter application measurement.
Refer to Operator’s Manual (Advanced Volume) for details.
5.13.2.4 Cine Review
Press <Freeze> to freeze the image and enter cine review state.
Or, click the cine to enter the cine review state.
5.13.3 STQ Imaging (Sound Touch Quantification)
The STQ imaging is an option. Probes support this function:
The SC5-1E and C5-1E probes support the STQ imaging in Adult ABD, Ped-ABD, ABD-Difficult,
EM ABD, EM FAST exam modes.
To Next Page
Loading...
Need help?
General
