To Next Page
H
Heather HollandSep 4, 2025
What to do if the lock/unlock switch does not respond on my Mindray Medical Equipment?
- SScott WilliamsSep 4, 2025
If the lock/unlock switch does not respond, the main board may be defective. Replace the main board.
What to do if the lock/unlock switch does not respond on my Mindray Medical Equipment?
If the lock/unlock switch does not respond, the main board may be defective. Replace the main board.
What causes vertical or horizontal lines on the Mindray T1 display?
If vertical or horizontal lines are displayed, the display is defective. Replace the front housing assembly.
Why is there no alarm sound being issued from my Mindray T1?
If no alarm sound is being issued, consider the following possible causes: * The audible alarm is disabled. Check if the “ ” icon is displayed. If yes, the audible alarm is disabled. Also, check if the “ ” icon is displayed. If yes, the alarm is paused or turned off. * Defective connection. Verify the connection between the main control board and the parameter connector board or the connection between the parameter connector board and the speaker. * Defective speaker. Replace the speaker. * Defective main board. Replace the main board.
Why is the alarm LED not lighting up on my Mindray Medical Equipment?
If the alarm LED does not light up, the main board may be defective. Replace the main board.
What causes program upgrade failures in Mindray T1 Medical Equipment?
Program upgrade failures can occur due to: * **Incorrect network connection:** Check the network connector on the patient monitor. Ensure the hub or switch is operating correctly and the correct network cable is in use and connected correctly. * **Wrong upgrade package:** The upgrade package shall be .pkg files. Select the correct .pkg file for your application. * **Incorrect IP address setting:** Configure a fixed IP address in range C as specified for the patient monitor. It is recommended not to perform software upgrades when T1 is connected to a network having multiple PCs. * **Defective main board:** Replace the main board.
Why does my Mindray Medical Equipment report 'Storage Card Err'?
If a 'Storage Card Err' is reported, it indicates an SD card error. Restart T1. If the problem persists, format the SD card.
Why is the display blank or black on my Mindray T1 Medical Equipment?
If the display is blank or black, it could be due to: * A loose display connection cable. Properly connect the display connection cable. * A defective display. Replace the front housing assembly.
How to fix touchscreen accuracy issues on Mindray T1?
If the touchscreen accuracy is off, calibrate the touchscreen.
Why is my Mindray Medical Equipment touchscreen not responding?
If the touchscreen is not responding, the display may be defective, and you should replace the front housing assembly.
Details on warnings, cautions, and notes for safe operation and handling of the patient monitor.
Procedures for upgrading the monitor's hardware, including IBP, ECG, and Wi-Fi functions.
Procedures for various performance tests including ECG, SpO2, NIBP, and others.
Tests for power-on, touchscreen calibration, battery, and network printing functionality.
Steps to access and utilize the factory maintenance menu for advanced settings.
Guide to identifying and resolving common problems with the patient monitor.
Specific tests and limits for electrical safety inspection as per standards.
General| Category | Patient Monitor |
|---|---|
| Battery Life | Up to 4 hours |
| Imaging Modes | Not applicable |
| SpO2 | Yes |
| Pulse Rate | Yes |
| ECG | Yes |
| NIBP | Yes |
| Temperature | Yes |
| Parameters | ECG, SpO2, NIBP, Temperature, Respiration |
| Connectivity | USB, Ethernet, Wi-Fi |
