System Dialog System Setup
26 - 18 V Series Operating Instructions
26.2.8 Configuring the Alarm Watch Tab
The Alarm Watch feature allows the simultaneous viewing of selected alarms for up to 16 beds from a
single monitor. The System Administrator can add different locations for each monitor to watch
based on the staffing and/or departmental needs. Default alarm watch locations are managed
through the password protected System Alarm Watch tab. All configured locations are automatically
included in the monitor’s list of watched beds. Any changes made (including the initial
configuration) to the System Alarm Watch settings do not take effect until the patient is either
discharged or the patient size is changed. Any active location on the V Series central network can
be added to the watched list.
FIGURE 26-11 Example System Setup (Alarm Watch Tab)
26.2.9 Adding an Alarm Watch Location
1. Select the Setup tab from the Navigation Area.
2. Select the System button, enter the password, then select the Accept button.
3. Select the Alarm Watch tab.
4. Select the Add Location button, then select a location from the list.
The location displays in the Alarm Watch grid.
NOTE: Only locations where room/bed information was entered are available
in the list.
NOTE: Once a location is added to the list, it remains on the list until it is
removed. The locations are listed alphabetically in the list box.
5. Select the Cancel or Accept button.
To Next Page
Loading...
Need help?
General
