Introduction Regional Oxygen Saturation (rSO2) (Optional)
3 - 2 Addendum to V Series Operating Instructions
3.1 Introduction
This chapter describes how to obtain Regional Oxygen Saturation (rSO2) values from a INVOS 5100C
System Monitor, and how to configure the alarm responses for this device at the V 12/V 21 monitor.
The INVOS system provides non-invasive and continuous information of changes in regional oxygen
saturation of blood. The measurement takes place in real time, providing an immediate indication of
a change in the critical balance of regional oxygen delivery and oxygen consumption. Refer to the
INVOS
®
5100C Cerebral/Somatics Oximeter Operating Manual for parameter specifications.
Patient Sizes
Intended patient types: Adult, Pediatric, and Neonate.
VDI Module Connector
The VPS module does not include the rSO2 parameter. The rSO2 parameter is available through the
serial port of a separate module called the V Device Integrator (VDI) (as shown in FIGURE 3-1).
FIGURE 3-1 Example VDI Module Connector
Display Setup
To see the rSO2, the rSO2 tile must be configured to display on the Main Screen. Refer to "Display
Options Dialog" on page 3-2 in the V Series Operating Instructions for additional information.
3.2 rSO2 Configuration
The rSO2 dialog (as shown in FIGURE 3-2) contains an Alarms tab and a Setup tab.
A description of each tab follows.
3.2.1 Navigating to the rSO2 Dialog
• Select the rSO2 digital tile.
OR
1. Select the Set
up tab from the Navigation Area.
2. Select the Parameters button.
3. Select the rSO2 butt
on.
The rSO2 dialog is d
isplayed (as shown in FIGURE 3-2).
To Next Page
Loading...
Need help?
General
