Electromagnetic Capability Product Specifications
29 - 58 V Series Operating Instructions
29.19.3 Radio Regulatory Compliance
RF Parameter
The V 12/V 21 including Wi-Fi module (FCC ID:PD9512ANM) complies with part 15 of the FCC Rules.
Operation is subject to the condition that this device does not cause harmful interference.
Operation of this equipment requires the prior coordination with a frequency coordinator
designated by the FCC for the Wireless Medical Telemetry Service.
The V 12/V 21 including PD9512ANM FCC Radio Compliance:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. this device may not cause harmful interference, and
TABLE 29-36
RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF
COMMUNICATIONS EQUIPMENT AND THE V 12/V 21
The V 12/V 21 is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. The customer or the user of the V 12/V 21 can help prevent electromagnetic interference by
maintaining a minimum distance between portable and mobile RF communications equipment (transmitters)
and the V 12/V 21 as recommended below, according to the maximum output power of the communications
equipment.
RATED MAXIMUM OUTPUT
POWER (P)
OF TRANSMITTER
IN WATTS (W)
SEPARATION DISTANCE (d) IN METERS (m) ACCORDING TO
FREQUENCY OF TRANSMITTER
150 kHz to
80 MHz
d = 1.2 x
80 MHz to
800 MHz
d = 1.2 x
800 MHz to
2.5 GHz
d = 2.3 x
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d
in meters (m) can be determined using the equation applicable to the frequency of the transmitter, where P is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE: At 80 MHz and 800 MHz, the separation distance for the higher
frequency range applies.
NOTE: These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reflection from
structures, objects and people.
ITEM
DESCRIPTION
IEEE 802.11b IEEE 802.11g
Operating Frequency Band (MHz) 2412~2462 2442~2452
Modulation DSSS OFDM
Transmitter Output Power (dBm) < 30 < 30
To Next Page
Loading...
Need help?
General
