What causes low brine pump voltage in MIOX Portable Generator?
If your MIOX Portable Generator displays a 'Low Brine Pump Voltage' message, first check fuse F6 on the control interface board. Second, adjust the brine boost pressure to between 3-5 PSI if it's excessive. Third, verify the feed water meets system specifications if there are high Total Dissolved Solids (TDS) in the water.
Why does my MIOX RIO H4 Portable Generator have low cell voltage?
If the MIOX Portable Generator shows a 'Low Cell Voltage', first reset the large breaker (CB1) in the switch gear panel. Second, the contactor may have failed. Third, verify that the feed voltage meets the specification if the AC voltage feeding the system is low.
How to fix DA System Failure in MIOX Portable Generator?
If your MIOX Portable Generator shows a DA System Failure, correct the external Dilution Air system failure. If an external Dilution Air system is not used, place jumpers across the input according to the wiring diagram.
How do I troubleshoot the diode temperature on my MIOX RIO H4 Portable Generator?
To address the diode temperature issue in your MIOX Portable Generator, first verify the cooling fan operation to ensure sufficient airflow to the transformer. Second, verify the operation of the current sensors to check for excessive current draw on the diode bank. Third, replace the temperature switch if it has failed.
Lists mechanical and plumbing tools required for OSG installation.
Details on electrical power connection for the OSG unit.
Procedures for removing and installing the electrolytic cell.
General safety precautions and warnings for system operation.
Explanation of soft and hard faults and their handling.
Conditions requiring cell replacement and return procedures.
Detailed steps for removing and installing the brine pump.
Required salt purity percentages for system operation.
General| Brand | MIOX |
|---|---|
| Model | RIO H4 |
| Category | Portable Generator |
| Language | English |
To Next Page
