• A new 16 port ONSP card is now available and offers protected ports for use in provisioning
extensions outside the building. The "protected" ports are designed to protect against light-
ening and surges. The 16 port ONSP card can be used in ASU II and AX platforms.
3300 ICP Release 8.0
• Release 8.0 introduces the MXe II Controller. It is equipped with 512 MB RAM and an
embedded 21363 DSP with an DSP Echo Canceller module.
• A new version of the Analog Main Board, AMB Version III, provides additional electrical
protection for ONS Ports 1 and 2. The CX/CXi and MXe II Controller (PN 50005090) support
protection on these ONS ports. The older MXe Controller (PN 50005080) does not support
protection on these ONS ports.
3300 ICP Release 7.1
• The 3300 AX is scalable from 64 to 200 IP phones, and is ideal where a high density of
analog devices is required.
3300 ICP Release 7.0
• The 3300 MXe Controller is scalable from 40 to 300 users (1400 for the expanded version),
and has an optional Analog Main Board, E2T processor, redundant hard drives, and redun-
dant power supplies.
• The Analog Services Unit II (ASU II) will support up to 32 ONS phones and up to 8 LS
trunks, depending on how the unit is configured with two available line cards: a 16 port ONS
card and a 4 + 12 port (4 LS/12 ONS) Combo card. The ASU II is the only ASU supported
in China.
• The T1/E1 Combo combines trunking and DSP functionality in a single card. The T1/E1
Combo card, available at Release 7.0, provides for resiliency. You must have two 3300
ICPs running Release 7.0 software and a T1/E1 trunk connected to both ICPs. The trunk
can fail over to the secondary ICP in the event of a primary ICP failure.
• The Application Processor Card (APC-CX(i)) is an embedded PC card. Installed in a CX
or CXi controller, the APC hosts the Mitel Standard Linux (MSL) that can run Mobile Exten-
sion and Teleworker Solution applications.
Supporting Documentation
Refer to Mitel OnLine for Customer Documentation and Knowledge Base Articles.
To Next Page
Loading...
