18
C
LEANING INSTRUCTIONS
CHAPTER 3 HARDWARE INSTALLATION
Cleaning Instructions
To clean an EX Controller, wipe with a soft dry cloth.
CAUTION: Do not use volatile liquids such as benzene or thinner as they can damage the unit's casing.
For resistant markings, wet a cloth with a mild detergent, wring well and then wipe off. Use a dry cloth to
dry the surface.
Installing the EX Controller
IMPORTANT: Before installing, ensure that you have read the EX Controller and GX Gateway Safety
Instructions document supplied with the controller.
To install an EX Controller on a flat surface or in a rack:
1. Make a note or take a picture of your unit's serial number before you begin the installation. The serial
number is located underneath the EX Controller casing.
2. Unpack the controller and go through the Package Checklist.
3. Apply the polyurethane self-adhesive black cylindrical bumper protective products to the bottom of the
controller. This will improve the airflow under the controller.
NOTE: Skip this step if you are installing the controller in a rack.
4. Install the controller on a flat surface or in a rack, making sure that the unit is at 20 cm (8 in.) from your
monitor, computer casing, or other peripheral, including speakers.
Mounting tools and equipment available.
Additional equipment available.
EX Controller received.
Regulatory compliance and safety information received.
Warranty card received.
Software version verified (download the latest Deployment Tool)
Rack, desktop mounting of chassis completed.
Initial electrical connections established.
Cable length limits verified.
Initial configuration performed.
Initial operation verified.
Task Verified by Date
咨询订购：400-010-8885、 Support@mitel.com.cn
To Next Page
Loading...
