24
R
UNNING THE EX CONTROLLER DEPLOYMENT TOOL TO INSTALL THE MIVOICE BUSINESS VIRTUAL MACHINE
CHAPTER 4 SOFTWARE INSTALLATION
3. Click Check for updates.
If an update is available, the system updates the Deployment Tool. The Progress window displays
the progress of the update. Verify the update by checking the version number displayed on the
top-right corner of the Deployment Tool home page.
Running the EX Controller Deployment Tool to Install the
MiVoice Business Virtual Machine
After you update the Deployment Tool, use the Deployment Tool to install the MiVoice Business system
software as a virtual machine on the EX Controller.
NOTE: If the deployment fails due to interruptions, such as a power or network outage, you must restart
the deployment procedure.
The Deployment Tool supports two modes of deployment to complete the installation, Full and Partial +
Finish.
Full deploy
The full deployment mode allows you to deploy the MiVoice Business system software in a single proce-
dure. After a full deployment, the controller starts the MiVoice Business virtual machine and shuts down
the Deployment Tool virtual machine.
Partial + Full deploy
The partial + finish deployment mode allows you to complete the deployment in two phases.
In the first phase, the EX Controller is partially deployed. That is, after a partial deployment, the Deploy-
ment Tool virtual machine continues to run, and the MiVoice Business virtual machine is shut down.
Partial deployment allows you to review and modify certain configuration parameters before you finish the
deployment later.
In the second phase, you can review and modify certain configuration parameters, and then finish the
deployment.
After you finish the deployment, the controller starts the MiVoice Business virtual machine and shuts down
the Deployment Tool virtual machine.
To run the EX Controller Deployment Tool to install the MiVoice Business virtual machine:
咨询订购：400-010-8885、 Support@mitel.com.cn
To Next Page
Loading...
