Mitel 50008229 - Trunk Configuration

36
P
OST-INSTALLATION TASKS
CHAPTER 4 SOFTWARE INSTALLATION
Trunk Configuration
After you perform the basic programming of the MiVoice Business System Administration Tool, you can
configure trunks automatically by executing configuration scripts in the Gateway Configuration
Scripts form (Trunks > Enterprise Gateways) of the MiVoice Business System Administration Tool.
NOTE: If you hover over the default configuration file, a Tooltip is displayed that provides information about
the default configuration file.
Trunk Configuration Details
T1/D4 E&M trunks Execute the following configuration scripts:
• To configure Immediate Start, execute:
mitel_T1_EAM_ulaw_immediate_ perslot.cfg
To configure Wink Start, execute:
mitel_T1_EAM_ulaw_wink_perslot.cfg
PRI trunks Execute one of the following configuration scripts depending on
the protocol provided by the PSTN:
To configure DMS-100 protocol per specific PRI slot, execute:
mitel_E1_Euro_ISDN_Euro_Cayman_perslot.cfg
mitel_E1_Euro_ISDN_Euro_Numeris_perslot.cfg
mitel_E1_Euro_ISDN_Euro_Standard_perslot.cfg
mitel_E1_Euro_ISDN_Euro_Telecom_Italian_perslot.cf
g
mitel_T1_DMS100_perslot.cfg
mitel_T1_DMS250_perslot.cfg
FXO trunk Execute the following configuration scripts:
• To configure FXO trunks that use loaded coils, execute:
mitel_fxo_north_america.cfg
To configure FXO trunks that use non-loaded coils, execute:
mitel_fxo_default.cfg
To disable the Dial Tone Detection Mode, execute:
mitel_Disable_Dialtone_Detection.cfg
咨询订购：400-010-8885、 Support@mitel.com.cn