Planning and Installation Guide Mitel SIP-DECT Multi-Cell for MiVoice Connect
12
UNDERSTANDING NETWORKING AND POWER REQUIREMENTS
This topic contains information about network and power requirements and
recommendations.
NETWORKING REQUIREMENTS AND RECOMMENDATIONS
The following are networking requirements and recommendations:
• Assign an IP address (DHCP or static) for each base (required).
• Use a switched 10 or 100 Mbps capable network connection to connect the base to
the VoIP network (recommended).
POWER REQUIREMENTS
The following are system power requirements:
• Handset charging stands require a non-switched AC outlet (100-240V 50/60 Hz)
within two meters of the charger.
• Bases are Class 2 devices.
UNDERSTANDING ENVIRONMENTAL REQUIREMENTS
Consider the following environmental guidelines when planning your DECT 600
installation:
• Mount bases indoors, in dry and protected areas, and connect these components
to indoor wiring only.
• Whenever possible, mount the base near the ceiling, vertically on the wall. Avoid
mounting on metal walls, metal beams, or on concrete structures containing steel
reinforcement.
• Bases must be placed with at least one meter of separation between units. Range
and system capacity might be reduced if components are located less than one
meter apart.
DECT 600 components emit RF radiation that is below all government and industry
limits. However, some devices containing sensitive microphones can be affected by
this radiation and should be kept at a distance from DECT 600 components.
UNDERSTANDING ARCHITECTURAL IMPACTS TO COVERAGE
Construction materials and architectural features at the installation site can greatly
impact base coverage.
To guarantee a seamless handover if a caller moves from one DECT base station zone
of coverage to another DECT base station zone of coverage, an accurate
synchronization of the DECT base stations is necessary.
To Next Page
Loading...
