Mitel SIP-DECT Multi-Cell for MiVoice Connect Planning and Installation Guide
9
to clean and complies with high hygiene requirements, making it ideally suited for the
healthcare sector, too. With its integrated sensor alarm the phone is ideal for security
professions or the prison and detention centres. An additional emergency call key makes the
Mitel 632 DECT Phone the ideal companion not just for security-related professions, but also
for hospitals and care facilities.
RFP 4x BASE STATION
The Base Station (RFP 44, RFP 45, RFP 47 and RFP 48) converts IP protocol to DECT
protocol and transmits the traffic to and from the wireless handsets over a channel.
The RFP 4x provides the following features:
• New hardware design to natively run the OMM (Open-Mobility-Manager) for up to
1024 users/handsets and 256 RFPs (Base Station).
• 8 simultaneous voice channel support for each RFP
• Supports Over-the-Air DECT Handset software upgrades
• Supports Over-the-Air Synchronization
This 4th RFP generation comprises of:
• RFP 44: DECT RFP as indoor model with 4 narrow band voice channels and internal
antennas.
• RFP 45: DECT RFP as indoor model with 8 narrow band voice channels and internal
antennas.
• RFP 47 (Indoor Unit): DECT RFP as indoor model with 8 narrow band voice channels and 2
SMA connectors for external directional antennas.
• RFP 47 DRC (Outdoor Unit): RFP 47 pre-installed with directional antennas and 3m cable in
an outdoor enclosure.
• RFP 48: DECT RFP with 8 narrow band voice channels + WLAN Access Point as indoor
model with internal antennas for DECT and WLAN.
WIRELESS BANDS
The following frequency bands are supported:
• 1880 – 1930 MHz (DECT)
• 1880 – 1900 MHz (10 carriers) Europe/ETSI. The standard (ETS 300 175)
essentially specifies the air interface, known as the radio interface. Voice and data
can both be transmitted using this interface.
• 1910 – 1930 MHz (10 carriers) LATAM
• 1920 – 1930 MHz (5 carriers) US
To Next Page
Loading...
