Mitsubishi Electric MELSEC iQ-R-R00CPU - Page 593

36 PROCEDURE FOR STARTING UP A SYSTEM USING THE SIL2 PROCESS CPU
36.1 Overview
591
36
Procedure for the remote head module side
1. Powering on the system
Check the system for the following and power on the system.
• Wiring to the power supply module is correct.
• The power supply voltage is within the range of specifications.
• The remote head module is in the STOP state.
2. Creating a project
Start the engineering tool and create a project. ( MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's
Manual (Startup))
3. Connecting the personal computer and the remote head module
Connect the personal computer on which the engineering tool has been installed and the remote head module. ( MELSEC
iQ-R CC-Link IE Field Network Remote Head Module User's Manual (Startup))
4. Initializing the remote head module
Initialize the remote head module with the engineering tool. ( MELSEC iQ-R CC-Link IE Field Network Remote Head
Module User's Manual (Startup))
5. Setting parameters for the remote head module side
Set system parameters, CPU parameters, and module parameters of each module. ( MELSEC iQ-R CC-Link IE Field
Network Remote Head Module User's Manual (Application))
• Set system parameters and CPU parameters.
• Set module parameters of each module.
6. Writing the parameters to the remote head module
Write the parameters set using the engineering tool to the remote head module. ( MELSEC iQ-R CC-Link IE Field Network
Remote Head Module User's Manual (Startup))
7. Resetting the remote head module
Restart the system on the remote head module side with either of the following methods.
• Powering off and on the system
• Resetting the remote head module ( MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's Manual
(Application))