APPX
Appendix 5 List of Special Register Areas
833
A
Appendix 5 List of Special Register Areas
The following table lists items in the list.
Do not change the data set by the system in a program or by a device test. Doing so may result in system
down or communication failure.
Item Description
No. Special register number
Name Special register name
Data stored Data stored in the special register
Details Detailed description of the data stored
Set by (setting timing) Set side of data (system or user) and timing when data is set by the system
<Set by>
•S: System
• U: User (program, engineering tool, GOT, or other testing operations from external device)
• U/S: User and system
<Set timing>
• Every END: Data is set every time END processing is performed.
• Initial: Data is set when initial processing is performed (e.g. powering on the system, changing the operating status from
STOP to RUN).
• Status change: Data is set when the status is changed.
• Error: Data is set when an error occurs.
• Instruction execution: Data is set when an instruction is executed.
• Request: Data is set when requested by a user (using the special relay).
• Switch change: Data is set when the switch of the CPU module is changed.
• Card insertion/removal: Data is set when an SD memory card is inserted or removed.
• Writing: Data is set when a user performs a writing operation.
• During END: Data is set when END processing is performed.
• System switching: Data is set when two systems are switched (between the control system and the standby system)
CPU The following shows the supported CPU modules. Each of the CPU module is represented by the following symbols.
• Rn: Programmable controller CPU
• RnP: Process CPU
• RnPSF: SIL2 Process CPU
• RnSF: Safety CPU
• ALL: All the above CPU modules
To Next Page
Loading...
