4 START-UP PROCEDURE
4.8 Setting Parameters
45
4
Setting parameters from the Navigation window
Set the following parameters from the Navigation window.
■System parameters
These parameters need to be set from the Navigation window in the following cases: to change the number of slots on the
base unit or the number of occupied points of the module; for a multiple CPU system; and for module synchronization
operations.
[Navigation window] [Parameter] [System Parameter]
■Module parameters of the CPU module
These parameters are required to execute the Ethernet function of the CPU module.
[Navigation window] [Parameter] [Module model name] [Module Parameter]
■Memory card parameters
These parameters are required to execute functions that access the SD memory card.
[Navigation window] [Parameter] [Module model name] [Memory Card Parameter]
■Multiple module parameters and module extension parameters
Some intelligent function modules require multiple module parameters and module extension parameters.
[Navigation window] [Parameter] [Module Information] [Intelligent function module] [Module Parameter] or
[Module Extended Parameter]
System parameters can be set on the following windows. Select the window depending on their application
purposes.
• Module Configuration window: Use this window when using the module specific data (such as number of
occupied points) as is.
• System Parameter window: Use this window when changing the number of slots or the number of occupied
points.
To Next Page
Loading...
