734
APPX
Appendix 8 Parameter List
*1 When the device/label operation save setting is set to "Do not save", the value is 3504H.
Module parameters
The following are the lists of module parameters.
Ethernet function
For the module parameters relating to the Ethernet function, refer to the following.
MELSEC iQ-R Ethernet User's Manual (Application)
Memory card parameters
The following is the list of memory card parameters.
Routing Setting Routing Setting 3800H
SFC Setting SFC Program Start Mode Setting 3C00H
Start Condition Setting 3C00H
Output Mode at Block Stop Setting 3C00H
Redundant System Settings Redundant System Behavior Setting 5000H
Tracking Setting Signal Flow Memory Tracking Setting 5001H
Tracking Device/Label Setting 5001H
Redundant System with Extension Base Unit Extension Cable Redundant Error Detection
Setting at Startup
5002H
Automatic Standby System Recovery Function 5002H
Item Parameter No.
Boot Setting Operation Setting at CPU Built-in Memory Boot 2000H
Boot File Setting
Setting of File/Data Use or Not in Memory Card Data for Label Communication 2010H
Module Extended Parameter
Item Parameter No.
To Next Page
Loading...
