APPX
Appendix 8 Parameter List
733
A
CPU parameters
The following is the list of CPU parameters.
Item Parameter No.
Name Setting Title Setting 3100H
Comment Setting 3101H
Operation Related Setting Timer Limit Setting 3200H
RUN-PAUSE Contact Setting 3201H
Remote Reset Setting 3202H
Output Mode Setting of STOP to RUN 3203H
Module Synchronous Setting 3207H
Clock Related Setting 3209H
Interrupt Settings Fixed Scan Interval Setting 3A00H
Fixed Scan Execution Mode Setting 3A00H
Interrupt Enable Setting in Executing Instruction 3A00H
Block No. Save/Recovery Setting 3A00H
Interrupt Priority Setting from Module 3A01H
Service Processing Setting Device/Label Access Service Processing Setting 3B00H
File Setting File Register Setting 3300H
Initial Value Setting 3301H
Label Initial Value Reflection Setting 3302H
File Setting for Device Data Storage 3303H
Memory/Device Setting Cassette Setting Extended SRAM Cassette 3404H
Device/Label Memory Area Setting Device/Label Memory Area Capacity Setting 3400H
Device Points 3401H
Local Device 3405H
Latch Range Setting 3407H
Latch Type Setting of Latch Type Label 3408H
Index Register Setting 3402H
Refresh Memory Setting 3403H
Device Latch Interval Setting 3406H
Pointer Setting 340BH
Internal Buffer Capacity Setting 340AH
Link Direct Device Setting 340DH
RAS Setting Scan Time Monitoring Time (WDT) Setting 3500H
Constant Scan Setting 3503H
Error Detections Setting 3501H
CPU Module Operation Setting at Error Detected 3501H
LED Display Setting 3502H
Event History Setting Save Destination 3507H
*1
Set Save Volume of Per File 3507H
*1
Online Module Change Function Setting Direct Change Setting 3505H
Program Setting Program Setting Program Name 3700H
Execution Type 3700H
Type (Fixed Scan) 3700H
Type (Event) 3701H
Detail Setting Information
Refresh Group Setting 3700H
Device/File Use or not 3700H
Both Systems Program Executions Setting 3700H
FB/FUN File Setting 3702H
Refresh Setting between Multiple
CPU
Refresh Setting (At the END) 3901H
Refresh Setting (At I45 Exe.) 3902H