Appendix - 8
Appendices
Buffer memory address Item
Memory
area
4300+100n
[Cd.3] Positioning start No.
Axis control data
Control data
4301+100n
[Cd.4] Positioning starting point No.
4302+100n
[Cd.5] Axis error reset
4303+100n
[Cd.6] Restart command
4304+100n
[Cd.7] M code OFF request
4305+100n
[Cd.8] External command valid
4306+100n
4307+100n
[Cd.9] New current value
4308+100n
4309+100n
[Cd.10] New acceleration time value
4310+100n
4311+100n
[Cd.11] New deceleration time value
4312+100n
[Cd.12] Acceleration/deceleration time change value during
speed change, enable/disable
4313+100n
[Cd.13] Positioning operation speed override
4314+100n
4315+100n
[Cd.14] New speed value
4316+100n
[Cd.15] Speed change request
4317+100n
[Cd.16] Inching movement amount
4318+100n
4319+100n
[Cd.17] JOG speed
4320+100n
[Cd.18] Interrupt request during continuous operation
4321+100n
[Cd.19] HPR request flag OFF request
4322+100n
4323+100n
[Cd.20] Manual pulse generator 1 pulse input magnification
4324+100n
[Cd.21] Manual pulse generator enable flag
4325+100n
[Cd.22] New torque value/forward new torque value
4326+100n
4327+100n
[Cd.23] Speed-position switching control movement amount
change register
4328+100n
[Cd.24] Speed-position switching enable flag
4330+100n
4331+100n
[Cd.25] Position-speed switching control speed change
register
4332+100n
[Cd.26] Position-speed switching enable flag
4334+100n
4335+100n
[Cd.27] Target position change value (New address)
4336+100n
4337+100n
[Cd.28] Target position change value (New speed)
4338+100n
[Cd.29] Target position change request flag
4339+100n
[Cd.43] Simultaneous starting axis
n: Axis No.-1
To Next Page
Loading...
