41
CHAPTER 3 SPECIFICATIONS
3
3.7 List of Remote Buffer Memory Areas
(a) Parameter area of extension modules
The remote buffer memory areas differ depending on the model of extension module.
• For the extension A/D converter module, refer to Page 44, Section 3.7.2 (1).
• For the extension D/A converter module, refer to CC-Link IE Field Network Digital-Analog Converter
Module User's Manual.
• For the extension I/O module, refer to CC-Link IE Field Network Remote I/O Module User's Manual.
(2) Monitoring area (address: 0500H to 09FFH)
*1 Value at the time of turning off and on the module power supply or at the time of remote reset.
*2 This shows whether reading/writing data from/to a program is possible.
R: Readable
W: Writable
(a) Monitor area of extension modules
The remote buffer memory differs depending on the model of the extension module.
• For the extension A/D converter module, refer to Page 45, Section 3.7.2 (2).
• For the extension D/A converter module, refer to CC-Link IE Field Network Digital-Analog Converter
Module User's Manual.
• For the extension I/O module, refer to CC-Link IE Field Network Remote I/O Module User's Manual.
Type
Address
Description
Default
value
*1
Read/Write
*2
Decimal Hexadecimal
Station-based monitor
data
1280 to 1535 0500H to 05FFH System area
Main module
Module-based monitor
data
1536 0600H System area
1537 0601H CH1 Maximum value 0 R
1538 0602H CH1 Minimum value 0 R
1539 0603H CH2 Maximum value 0 R
1540 0604H CH2 Minimum value 0 R
1541 0605H CH3 Maximum value 0 R
1542 0606H CH3 Minimum value 0 R
1543 0607H CH4 Maximum value 0 R
1544 0608H CH4 Minimum value 0 R
1545 to 1791 0609H to 06FFH System area
Extension module 1
Module-based monitor
data
1792 to 2047 0700H to 07FFH
The remote buffer memory areas of the
connected extension module are assigned.
2048 to 2559 0800H to 09FFH System area
To Next Page
Loading...
