Mitsubishi FREQROL-SF User Manual

r
Parameter No. on the NC screen when the equipment is linked with
M330HM/335M through the bus:
r
Parameter No.
on the NC screen when the equipment is linked with
M310/320/330 through the bus:
#
# No.
Parameter
Description
Setting range (unit)
The spindle orientation direction, detec-
tor installed direction, and motor rota-
tion direction are set.
[Magnesensor orientation]
Standard setting: 0020
(0120 when the detector installation
direction is reversed)
[Encoder orientation]
Standard setting: 0120
(0020 when the detector ins,tpllation
direction is reversed)
Oriented
0 48 16 0RS2 spindle stop
control 2
Hexadecimal notation
O:Close(with
rotation)
10: cw (Hotor
?32”e?CSe
rotation)
11: Prohibited
PFE... same a.5
1:Semiclose direction.
EMG, in-position
tput is not held.
aint exci-
l:In EHG, in-position
output is held.
citation
Normally: 0
+)drrection
(Note) The position loop
-1direction
means the synchro-
nous tap.
O:(+)directux
l:(-)direction
- .xne parameters Deing asterisked are set from the NC when the equipment is linked with the
M300 series machine through the bus line.
-194-

Mitsubishi FREQROL-SF Specifications

General

Brand	Mitsubishi
Model	FREQROL-SF
Category	DC Drives
Language	English