39
-
3A
-
3B
-
3c
-
3D
-
3E
-
3F
-
40
-
41
-
*
Parameter No.
on the NC screen when the equipment is linked
M330HMI33M
through the bus:
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
-
with
r
Parameter
No.
on the NC screen when the equipment is linked with
/
M310/
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
-
20/330
through the bus:
GRA
GFtA
-
GRA
GRB
-
GRB
GRB
OSL
Parameter
Number of gear
teeth on spin-
dle side
Number of gear
teeth on motor
shaft side
Orientation
type
T
L
Description
The number of gear teeth on the spindle
side against the gear 00 is converted
into hexadecimal notation and set.
The number of gear teeth on the spindle
side against the gear 01 is converted
into hexadecimal notation and set.
.
The number of gear teeth on the spindle
side against the gear 10 is converted
into hexadecimal notation and set.
The number of gear teeth on the spindle
side against the gear 11 is converted
into hexadecimal notation and set.
The number of gear teeth on the motor
shaft side against the gear 00 is
converted into hexadecimal notation
and set.
The number of gear teeth on the
motor
shaft side against the gear 01 is
converted into hexadecimal notation
and set.
The number of gear teeth on the motor
shaft side against the gear 10 is
converted into hexadecimal notation
and set.
The number of gear teeth ont he motor
shaft side against the gear 11 is
converted into hexadecimal notation
and set.
The orientation method is set.
0: Motor built-in encoder
1: Encoder
2: Magnesensor
co
Setting range (Unit)
1 to 7FFF (Hex).
However, on the NC
screen,
it is in the
range from 1 to 32767
(in decimal notation),
which is not required
to convert into hexa-
decimal notation.
The gear rate is set
by the number of gear
teeth on the spindle
side and that on the
motor shaft side.
Spindle speed
number of gear teeth
on soindle side
(GRAi
to 4)
Xnumber of
qear
teeth
on motor shaft side
(GRB~
to
4)
= motor speed
1 to 7FFF (Hex).
However, on the NC
screen,
it is in the
range from 1 to 32767
(in decimal notation),
which is not required
to convert into hexa-
decimal notation.
The gear rate is set
by the number of gear
teeth on the spindle
side and that on the
motor shaft side.
Spindle speed
number of gear teeth
on
swindle
side
(GRAi
to 4)
'number of gear teeth
on motor shaft side
(GRB~
to
4)
= motor speed
Hexadecimal
3-
.1
lnuea
on
tne
next page.
The parameters being asterisked are set from the NC when the equipment is linked with the
M300 series machine through the bus line.
-197-
To Next Page
Loading...
Need help?
General