Mitsubishi FREQROL-SF - Parameter No. of parameter error

Parameter No.
on the NC screen when the equipment is linked with
~33Q~t4/33M through the bus:
r
Parameter No.
on the NC screen when the equipment is linked with
M310/320/330 through the bus:
#
Parameter Description
Setting range (unit)
FEDCBA9876543210
42 BSL Bit assign-
n-lent
Speed refer-
0: open emitter
1: open collec-
Alarm code at-
in case of
external EMG
0: Presence
1: Absence
Hexadecimal
notation
PosItion command,
oriented spindle
stop
0: open emitter
1: open collec-
tor
External EMG
0: Invalid
Machine ready
signal in NC
mode
0: Invalid
1: Valid
0: Load meter
output 1ov
1: Load meter
output 3v
l
The parameters being asterisked are set from the NC when the equipment is linked with the
M300 series machine through the bus line.
-198-