3 - 1 3 - 1
MELSEC-
3 SPECIFICATIONS
3 SPECIFICATIONS
This chapter provides the specifications of the AJ65SBT-CLB.
3.1 General Specifications
Table 3.1 General specifications
Item Specifications
Operating ambient
temperature
0 to 55°C
Storage ambient
temperature
-25 to 75°C
Operating ambient
humidity
5 to 95%RH, non-condensing
Storage ambient
humidity
5 to 95%RH, non-condensing
Frequency Acceleration Amplitude Sweep count
10 to 57Hz ———
0.075mm
(0.003inch)
Under
intermittent
vibration
57 to 150Hz
9.8m/s
2
———
10 to 57Hz ———
0.035mm
(0.001inch)
Vibration resistance
Conforming
to
JIS B 3502,
IEC 61131-2
Under
continuous
vibration
57 to 150Hz
4.9m/s
2
———
10 times each in
X, Y, Z directions
(for 80 min.)
Shock resistance
Conforming to JIS B 3502, IEC 61131-2 (147 m/s
2
, 3 times in each of 3 directions X, Y, Z)
Operating ambience No corrosive gases
Operating altitude 2000m (6562ft.) max.
Installation location Inside control panel
Overvoltage
category 1
II max.
Pollution degree 2 2 max.
1 : This indicates the section of the power supply to which the equipment is assumed to be connected
between the public electrical power distribution network and the machinery within premises. Category II
applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300 V is 2500 V.
2 : This index indicates the degree to which conductive material is generated in terms of the environment
where the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs but temporary conductivity may be produced
due to condensation.
3 : Do not use or store the programmable controller under pressure higher than the atmospheric pressure of
altitude 0m.
Doing so can cause a malfunction.
When using the programmable controller under pressure, please contact your sales representative.
3
To Next Page
Loading...
